command activated standby dds signal generator

... port commands—for both continuous wave (CW) and sweep output modes. Users can easily regulate output power attenuation levels through commands. When idle, it enters standby mode via command, ensuring energy efficiency. Powered by 9V (700mA current)

...Generator Sets Synchronous Running SHX full auto synchronous control system has auto synchronization and auto parallel operation for each genset: When one genset is running on load, if the load is close to 80% of rated load (adjustable), send signal of genset adding automatically, standby genset starts up automatically, and parallel operation automatically after auto synchronization, distribute active

... commands for an associated actuator. It is equipped with a high-output sensor circuit, enabling it to effectively process signals from speed sensors that produce higher voltage outputs, contributing to robust and reliable operation. Typically, it